|
| | |
Cat Pan Liner
Only $8.35
100% biodegradable, non-allergenic cat pan liner
|
| | |
The Flushable Bag™
Only $16.15
On SALE for only $14.50
The responsible way to deal with your pet's waste!
|
Guest Registration
|
Hatchbag >>
More Information
TIPS AND HINTS
--------------------------------------------------------------------------------
FOR LINERS AND NETS
CLEANING This is very critical and the newer the vehicle, the more careful you must be in removing the silicone from the surface of the plastic/vinyl. Use a clean cloth and wipe each area where an adhesive patch will adhere. Clean 6-7 times at each location using a clean area of cloth with lacquer thinner and wiping just a few seconds. This will soften the silicone and lift a little off with each treatment. If the adhesive does not adhere to the surface, then all this silicone was not removed. Repeat the cleaning instructions again…You can order more adhesives from us @ no charge.
REMOVING Adhesives – The velcro type adhesives that mount to the vehicle are not permanent. There is no apoxy, glue or dyes…When you get ready to remove them permanently, any residue that remains can be easily removed with any household cleaner…I have found in taking off this sticky residue over the years, that a good solution of hot soapy (powdered detergent works best) water, then wipe with alcohol does a good job….You will never know they were there, but the interior of the vehicle will look just the same as when you drove it off the dealers lot…..
We have used our liner for years in our Suburban and have found that loosening the plastic molding that holds the carpet down in the back and slipping the end of the liner under this piece and tightening it back down, holds the liner in place and keeps any dirt, sand, or grit from working underneath.
If you are using your cargo area to slide crates or boxes in and out, you may want to put 3 strips of the hook(hard) side of a velcro type fastener on the bottom of the liner and press it into the carpet to keep the liner from slipping when sliding items in and out…3 Pieces cut the width of the bottom and placed on bottom of liner spaced evenly from front to back will give a good secure hold.
--------------------------------------------------------------------------------
FOR SHERPA ROOF TOP CARRIER
When the roof top carrier is not filled to its maximum capacity, it will cause wind shearing, which causes material damage. Roof top carrier must be completely filled. When unable to fill the Sherpa, pack large spaces with pillow, polyfoam, sleeping bags, etc. This prevents shifting of the cargo.
When you have traveled approximately 10 miles or 10 minutes, find a safe place to pull off road and tighten the straps and tie off the loose end of strap. This will prevent noise from this loose end flapping on side of vehicle and the Sherpa. It will also prevent the strap from causing material abrasion.
We have on several occasions not been able to completely fill our Sherpa as tightly as we like. We have used bungee cords to help secure the carrier and this helps keep the material from wind shear damage. Attach to the roof rack and stretch over the top of Sherpa. Is best if you can criss-cross the bungees.
--------------------------------------------------------------------------------
Questions and Answers
Q. Can my dog’s claws puncture the material?
A. No. It would take a sharp metal object to puncture or cut this material.
Q. Is the material slippery?
A. No. It has a textured finish that will prevent your pet from slipping.
Q. Is the material padded?
A. No. There is no padding.
|